If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
JJ Sinclair wrote:
Good luck on getting high enough, this time of year, to generate enough pressure to dislodge the pesky little critters. Ah JJ, you forget that motorgliders can have some advantages! I will try my idea since it can't hurt and one is always partial to one's own ideas. The stuff I've seen coming out is so waxy that I think softening it might help. I forgot to mention the mud-dobbers are partial to fiberglass also. ... My entomological education continues.- I am going to have to pay more attention to those critters. ... after heating up the probe hole with an air gun. You lost me here - I don't recall mentioning _heating_ the probe hole ?? Jack |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Good plans-built Light Sport Aircraft | Rob Schneider | Home Built | 15 | August 19th 04 05:50 PM |
Free Volksplane to good home, located in Chino Hills CA | Bryan Zinn | Home Built | 3 | July 18th 04 02:55 AM |
Cleaning a 3-way TE probe | Jack Glendening | Soaring | 37 | November 5th 03 06:45 PM |
bulding a kitplane maybe Van's RV9A --- a good idea ????? | Flightdeck | Home Built | 10 | September 9th 03 07:20 PM |
Broken line to Oil Temperature Probe, Repairable? | rkane33 | Owning | 2 | July 25th 03 03:19 AM |