|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 29th 20, 05:44 PM
posted to rec.aviation.soaring
|
|||
|
|||
Cobra Trailer Sidewall Seal Replacement Hints?
Has anyone replaced the "sidewall seal" on a Cobra trailer?
This is rubber gasket that runs along the top of the trailer's bottom half side walls and seals it to upper trailer shell. There is also the identical gasket at the front of the trailer which seems much difficult to access short of removing the top. If you have done this do you have any hints and tricks to share? Thanks, John DeRosa OHM Ω 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trailer seal replacement | Mark Olinger | Soaring | 4 | December 31st 15 01:46 AM |
| Cobra trailer seal replacement--any previous experience? | John Duke | Soaring | 4 | October 5th 15 08:03 PM |
| Cobra trailer wing dolly plastic sidewall rollers? | [email protected] | Soaring | 4 | May 9th 13 10:52 PM |
| Cobra trailer weatherstrip replacement | Larry Goddard | Soaring | 0 | November 25th 09 05:26 AM |
| Cobra Trailer Replacement Wheel | Chip Bearden | Soaring | 5 | September 29th 09 08:35 PM |
Threaded Mode