If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#41
|
|||
|
|||
Avionics (Radio Problem) Narrowed Down... I Think???
All righty then...
Consider this thread closed. I'm going to count my blessings and be happy I can communicate, and focus on the aviate part again! ;-) I'll start putting some money aside and start upgrading my panel the next time a piece of avionics goes toes-up. Thanks again to all for your input. and... for the record... I realized after my last send, that I do know what a Printed Circuit Board is... ;-) Best Regards, Todd |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
MX385 Radio removal | Marty from Florida | Owning | 3 | May 24th 13 08:26 AM |
Engine Balancing and Resonance Vibration Problem | AllanFuller | Owning | 13 | September 12th 05 12:51 AM |
(sorta OT) Free Ham Radio Course | RST Engineering | Home Built | 51 | January 24th 05 08:05 PM |
(sorta OT) Free Ham Radio Course | RST Engineering | Piloting | 43 | January 24th 05 08:05 PM |
RF interference issue again (esp. for E Drucker and Jim Weir and other RF wizards) | Snowbird | Home Built | 78 | December 3rd 03 09:10 PM |