If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Probe problem
I changed a bad probe on one cyl. My Hanger mate and I had about 8
spares.with very little time. I tried 6 of these and the same thing happened. . When I snugged it up to the exaust pipe it would read 76..If I took it out and put heat to it it worked ok. I did this to 5 or 6 and the same thing happened. As soon as I snug it up it would not work. I can't figure out what is happening. I know all the probes can't be bad . any ideas Steve |
#2
|
|||
|
|||
Probe problem
"smf" wrote in message ... I changed a bad probe on one cyl. My Hanger mate and I had about 8 spares.with very little time. I tried 6 of these and the same thing happened. . When I snugged it up to the exaust pipe it would read 76..If I took it out and put heat to it it worked ok. I did this to 5 or 6 and the same thing happened. As soon as I snug it up it would not work. I can't figure out what is happening. I know all the probes can't be bad . any ideas Try starting your engine after you install them. (GD&R) -- Jim in NC |
#3
|
|||
|
|||
Probe problem
Try heating one up and then touching it to the engine to see if the
problem has to do with a short to ground in the wires or gage. |
#4
|
|||
|
|||
Probe problem
I switched the probes and the problem went to the other cyl. It must be
some sort of ground problem because it doesn't quit working until the probe is snugged up against the pipe. steve "Bob Kuykendall" wrote in message oups.com... Try heating one up and then touching it to the engine to see if the problem has to do with a short to ground in the wires or gage. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
TE Probe on ASW-15 | [email protected] | Soaring | 4 | April 29th 07 01:43 AM |
Outside air temperature probe | dlevy | Owning | 9 | November 7th 06 05:14 PM |
More on CHT probe replacement | Jim Burns | Owning | 12 | September 1st 05 10:45 PM |
TE-Probe for 1-26D | Heinz Gehlhaar | Soaring | 6 | January 17th 05 10:52 PM |
TE probe for SGS2-33 | Rod Pool | Soaring | 1 | May 20th 04 06:08 PM |