A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups » Rotorcraft
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Inflatable Rotors (Flying Car?)



 
 
Thread Tools Display Modes
  #3  
Old July 30th 03, 04:20 PM
wmbjk
external usenet poster
 
Posts: n/a
Default


"sanman" wrote in message
om...

So you'd be riding a sort of lightweight automotive vehicle along the
road, and you could switch to helicopter mode, with inflatable rotors
popping out on the top of your vehicle. Your engine would then power
the rotors, and you'd fly away. Once you landed again, the deflated
rotors would be tucked back into whatever compartment they'd popped
out from.

Cmon, there are all kinds of wierd-looking lightweight concept cars
out there, so why not this? What would be the main difficulties with a
concept like this?


Woodpeckers.

Wayne


  #4  
Old August 1st 03, 01:07 AM
sanman
external usenet poster
 
Posts: n/a
Default

Well, polymers and reinforcement fiber technology are continuing to
improve. You can even buy carbon-fiber reinforced polymers these days,
with superduper tensile strength. But I would imagine that kevlar,
spectra, vectran would have enough strength to do the job for a small
personal transportation vehicle. They would be able to handle the high
pressures.

To ease the load requirements, the rotor could be 4-vaned. Each pair
of opposing vanes could have a commonly inflated structure -- that way
if a single vane suffered a rupture, then it and its opposing partner
could be deflated/depressurized, while the remaining pair of rotor
vanes would take the load while you landed. Or why not even a 6-way
rotor?

Someone who responded to my posting suggested weighting the rotor tips
for flywheel effect. The centrifugal force from the weighted tips
would help to keep the rotors rigid and reduce the possibility of
buckling. Flywheel energy could also help in the event of an unpowered
landing due to engine failure.
  #5  
Old August 1st 03, 05:20 AM
Dan & Jan Hollenbaugh
external usenet poster
 
Posts: n/a
Default

I don't recall inflatable wings, but both telescoping and "ribbon" blades
have been tried. IIRC, the cloth rotor had a wire "spar" with a tip weight,
and a cloth single panel sail-like "blade". Also IIRC, the idea was to use
it in autorotation mode, as a deceleration device in place of a parachute.

Rigid telescoping blades have also been tried experimentally. The variable
diameter allowed for two flight regimes - high speed (with outer portion
retracted) and low speed (outer portion extended, more lift for hover
profiles).

I've got some info on my work computer, I'll try to post it later.

Dan Hollenbaugh
AnyBody43 wrote in message
. ..
Mark Hickey wrote in message

. ..
(sanman) wrote:

I was reading about inflatable wings:

snip
So you'd be riding a sort of lightweight automotive vehicle along the
road, and you could switch to helicopter mode, with inflatable rotors
popping out on the top of your vehicle. Your engine would then power
the rotors, and you'd fly away. Once you landed again, the deflated
rotors would be tucked back into whatever compartment they'd popped
out from.

Cmon, there are all kinds of wierd-looking lightweight concept cars
out there, so why not this? What would be the main difficulties with a
concept like this?


Given that centrifugal force keeps the rotors from folding upwards
anyway it seems a relatively small change in the principles of operation
to have such a mechanism.

If inflatible was no good how about folding/telescopic . . .
or just ribbon/strip with a weight on the end.


## Miniature emergency parachute hat ##

Since the "wing" area of a helicopter is much less than that of
a parachute, and that a helicopter CAN land softly without an engine
why not have a small device that:-

Is an auto gyro that infates out of a bag
Uses gas jets to accelerate the blades to operating speed
lowering the wearer safely to the ground.
Would be smaller and lighter than a conventional parachute?
Maybe a pyrotechic charge could be used as a gas source?

Perhaps a small hand grenade would be enough to get it going



 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Routine Aviation Career Guy Alcala Military Aviation 0 September 26th 04 12:33 AM
Flying is Life - The Rest is Just Details Michael Piloting 55 February 7th 04 04:17 PM
Wm Buckley on John Kerry Big John Piloting 22 February 7th 04 03:19 AM
Announcing THE book on airshow flying Dudley Henriques Piloting 11 January 9th 04 08:33 PM
Inflatable Rotors (Flying Car?) Ken Sandyeggo Rotorcraft 2 August 6th 03 06:37 AM


All times are GMT +1. The time now is 11:36 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AviationBanter.
The comments are property of their posters.