|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 27th 06, 05:45 PM
posted to rec.aviation.homebuilt,rec.aviation.owning
|
|||
|
|||
pvc tubing/sleeve source?
I'm looking for a source for about 50 ft of 5/8" dia. non-heat shrink Mil
spec 631 or 7444 pvc electrical tubing to run a couple of wire bundles. I've found plenty of places that sell it by the roll, and aircraft spruce has small diameter, but I haven't found a source for quantities less than 100 ft in 5/8" diameter. Any ideas? Thanks. Jim 
|
|
#2
September 27th 06, 09:35 PM
posted to rec.aviation.homebuilt,rec.aviation.owning
|
|||
|
|||
|
pvc tubing/sleeve source?
In rec.aviation.owning Jim Burns wrote:
I'm looking for a source for about 50 ft of 5/8" dia. non-heat shrink Mil spec 631 or 7444 pvc electrical tubing to run a couple of wire bundles. I've found plenty of places that sell it by the roll, and aircraft spruce has small diameter, but I haven't found a source for quantities less than 100 ft in 5/8" diameter. Any ideas? Thanks. Jim www.digikey.com -- Jim Pennino Remove .spam.sux to reply.
|
|
#3
September 27th 06, 09:40 PM
posted to rec.aviation.homebuilt,rec.aviation.owning
|
|||
|
|||
|
pvc tubing/sleeve source?
"Jim Burns" wrote in message
news  I'm looking for a source for about 50 ft of 5/8" dia. non-heat shrink Mil spec 631 or 7444 pvc electrical tubing to run a couple of wire bundles. I've found plenty of places that sell it by the roll, and aircraft spruce has small diameter, but I haven't found a source for quantities less than 100 ft in 5/8" diameter. Any ideas? Boeing Surplus http://www.boeing.com/assocproducts/surplus/retail/ Some of the guys on rah stop by there often. You might get one of them to look for the stuff. Rich S.
|
|
#4
September 27th 06, 11:49 PM
posted to rec.aviation.homebuilt,rec.aviation.owning
|
|||
|
|||
|
pvc tubing/sleeve source?
Jim Burns wrote: I'm looking for a source for about 50 ft of 5/8" dia. non-heat shrink Mil spec 631 or 7444 pvc electrical tubing to run a couple of wire bundles. I've found plenty of places that sell it by the roll, and aircraft spruce has small diameter, but I haven't found a source for quantities less than 100 ft in 5/8" diameter. Any ideas? Thanks. Jim Ya looking for the stc'd faa/pma stuff???
|
|
#5
September 28th 06, 03:36 AM
posted to rec.aviation.homebuilt,rec.aviation.owning
|
|||
|
|||
|
pvc tubing/sleeve source?
631 and 7444 is approved via Part 43, that's what I'm lookin for.
thanks Jim wrote in message ups.com... Jim Burns wrote: I'm looking for a source for about 50 ft of 5/8" dia. non-heat shrink Mil spec 631 or 7444 pvc electrical tubing to run a couple of wire bundles. I've found plenty of places that sell it by the roll, and aircraft spruce has small diameter, but I haven't found a source for quantities less than 100 ft in 5/8" diameter. Any ideas? Thanks. Jim Ya looking for the stc'd faa/pma stuff???
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A Remote Compass- java source | [email protected] | General Aviation | 0 | July 3rd 04 06:39 PM |
| Is AWC an approved weather source? | Andrew Sarangan | Piloting | 1 | June 26th 04 01:01 PM |
| Winscore source code now available | Guy Byars | Soaring | 0 | February 5th 04 10:43 AM |
| Source for copper crush gaskets??? | Jim | Home Built | 2 | August 22nd 03 09:44 PM |
| Source for copper crush gaskets??? | Jim | Owning | 0 | August 22nd 03 06:31 PM |
Linear Mode
