If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Got a problem with my wooden spar.
I was working on one wing when the other wing (and I'm guessing)
vibrated of the supports onto the concrete. It broke the end rib which I will have to build a new one. but it also broke one of the two 3/4 x 3/4 parts for the rear spar 12" from the end. Any ideas on how to fix this? I'm thinking it's going to take cutting the broken part out in a scarf style cut and replacing with a scarf joint, then sistering another part onto the inside. Then just for the heck of it T-88 a piece of ply across both parts at the joint. Anyone want to comment? Lou |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wooden gliders | Chris Davison | Soaring | 6 | March 22nd 07 02:02 PM |
Wooden Propellers | Danny Deger | Piloting | 11 | March 4th 07 10:17 AM |
Wooden propellor again | G0MRL | Aviation Marketplace | 1 | March 1st 06 05:22 PM |
Wooden Notes | [email protected] | Home Built | 22 | January 28th 06 10:29 PM |
Wooden Propellers | Dick Petersen | Home Built | 5 | November 13th 03 12:41 AM |