|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 24th 04, 10:35 PM
|
|||
|
|||
Metric measuring tool source?
Anyone know of a good source for metric measuring tools suitable for building a
sheet metal airplane such as Zenith's 601XL? Planning to check Sears or possibly Walmart. I figure I need a steel tape measure and ruler, and possibly a metric square with level assuming one with metric is sold here... 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FS: Papco #600 Flaring Tool | Michael Burton | Home Built | 0 | October 27th 03 05:26 PM |
| canopy breaking tool? | Russell Duffy | Home Built | 33 | September 30th 03 11:39 PM |
| Source for copper crush gaskets??? | Jim | Home Built | 2 | August 22nd 03 09:44 PM |
Threaded Mode