|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 15th 07, 01:57 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
routing of multiple antenna cables in wood homebuilt
I am building a GP-4.
I am starting to fabricate the following antennas for the rear fuselage: transponder comm 1 vor/glideslope marker beacon My question is can I bundle all of the coax into one run forward, or should there ideally be some minimum separation from the cables in order to minimize any interference from one another. Thanks 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 396 and routing | dlevy | Piloting | 4 | April 21st 06 05:11 PM |
| 396 and routing.... | dlevy | Instrument Flight Rules | 2 | April 20th 06 10:47 PM |
| Preferred Routing | Anthony Acri | Instrument Flight Rules | 1 | December 26th 04 04:15 PM |
| Preferred Routing | john smith | Instrument Flight Rules | 11 | September 19th 04 08:10 PM |
| MiG-29 cables | alcatraz | Military Aviation | 0 | March 1st 04 10:01 PM |
Threaded Mode