|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 17th 04, 02:59 PM
|
|||
|
|||
WTB Tall Redrive 503 Rotax
Hi
I'm looking to buy a Tall Redrive (cog belt) for a 503 (Prov 4) Rotax engine. This redrive will be used for a Challenger II to allow a 60 inche prop. Thank you 
|
|
#2
February 29th 04, 10:43 AM
|
|||
|
|||
|
Found one
Thank you "Jean-Paul Roy" wrote in message .. . Hi I'm looking to buy a Tall Redrive (cog belt) for a 503 (Prov 4) Rotax engine. This redrive will be used for a Challenger II to allow a 60 inche prop. Thank you
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dennis Fetters Mini 500 | EmailMe | Home Built | 70 | June 21st 04 09:36 PM |
| RV-9A's wing with Rotax 914? | Shin Gou | Home Built | 26 | March 7th 04 08:56 PM |
| WTB Tall Redrive Rotax 503 | Jean-Paul Roy | Aviation Marketplace | 1 | February 29th 04 10:44 AM |
| WTB Tall Redrive 503 Rotax | Jean-Paul Roy | General Aviation | 1 | February 29th 04 10:44 AM |
| WTB Tall Redrive 503 Rotax | Jean-Paul Roy | Home Built | 0 | February 17th 04 03:02 PM |
Linear Mode
