|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 9th 10, 01:02 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
C85 and O200 piston
Hello,
I want to place C85 piston inside an O200 engine. Do these pistons need any machining to fit? Thanks -- http://www.youtube.com/v/k6AP4SbRHNo...s=1&rel=0 Philippe Vessaire Ò¿Ó¬ 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| O200 overhaul | Philippe[_4_] | Home Built | 0 | May 30th 10 08:38 PM |
| O200 titan cylinders | Philippe Vessaire[_3_] | Home Built | 7 | November 4th 08 06:10 PM |
| O200 cylinder | Philippe Vessaire[_3_] | Home Built | 3 | October 19th 08 11:21 AM |
| O200 engine | Philippe Vessaire | Home Built | 7 | August 17th 07 08:53 PM |
| O200 nose | Philippe | Home Built | 0 | July 22nd 05 08:09 PM |
Threaded Mode