If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
tie down plates
|
#12
|
|||
|
|||
tie down plates
"David Lesher" wrote in message ... We now plan to put down pressure-treated 2*4's 12' long; drilled at ~30 degree angles to the vertical. We'll use ~30' lengths of rebar with a welded nut & a fender washer or two, and hammer them into the clay. Then we'll lag-screw the structure legs to the 2x4's. 30'...or 30" |
#13
|
|||
|
|||
tie down plates
"Blueskies" writes:
"David Lesher" wrote in message ... We now plan to put down pressure-treated 2*4's 12' long; drilled at ~30 degree angles to the vertical. We'll use ~30' lengths of rebar with a welded nut & a fender washer or two, and hammer them into the clay. Then we'll lag-screw the structure legs to the 2x4's. 30'...or 30" Yea, 30 inch long rebars, spread along two twelve foot long 2x4's... Unless it rains a LOT in the meantime, it will be hard enough to get those in... -- A host is a host from coast to & no one will talk to a host that's close........[v].(301) 56-LINUX Unless the host (that isn't close).........................pob 1433 is busy, hung or dead....................................20915-1433 |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Govt Plates | Mike Granby | Instrument Flight Rules | 103 | November 27th 06 07:12 AM |
Backup plates on PDA | Stan Prevost | Instrument Flight Rules | 29 | December 10th 04 02:42 AM |
Plates for PDA? | Kelly Bakst | Instrument Flight Rules | 29 | September 3rd 04 05:21 AM |
data plates | Del Rawlins | Home Built | 2 | August 21st 04 10:34 PM |