|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
|
Thread Tools | Display Modes |
|
#11
May 6th 13, 05:40 PM
posted to rec.aviation.soaring
|
|||
|
|||
Flarm Butterfly display
The larger font of 3.1 also has an issue in landscape mode. The data block for the selected target is shown in the upper right of the display. When the selected target is no longer received the residue of the left side of the target data remains displayed after the data block is removed. It appears that the "clear area" specification was not updated to correspond to the larger font size.
Result is an block of garbage at 2 o'clock on the outer range ring. It goes away when the target is deselected. Andy 
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Power Flarm Display | SteveB_Z5 | Soaring | 64 | March 25th 13 08:17 PM |
| Updating Software on Butterfly 57 mm version 2.1 display w/o Cable? | 3Y | Soaring | 7 | December 31st 12 12:50 PM |
| Butterfly external display questions | Andy[_1_] | Soaring | 30 | October 15th 12 07:20 AM |
| This Just In- Butterfly | [email protected] | Soaring | 6 | February 17th 12 09:00 PM |
| Best PDA/PNA for FLARM display? | Frank Paynter[_2_] | Soaring | 14 | August 28th 11 09:24 AM |
Linear Mode
