If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Need help getting ILEC SN10 winds to Oudie
Has anyone had any luck getting wind info from the SN10 to the Oudie?
I'm getting good GPS info from the SN10 but the wind readout on the Oudie is blank. ILEC is set to "output to PDA" and at 4800 baud rate. Oudie is set to Com4 (serial cable) at 4800 baud rate, parity none, 8 bits, stop bit 1. On Hardware page Ilec SN10 is the selected device and all boxes below are checked. Thanks for any help. G |
#2
|
|||
|
|||
Need help getting ILEC SN10 winds to Oudie
Again:
- Oudie is definitely receiving GPS position from SN10 - no wind is received. Does anyone know if Oudie implements: http://www.nadler.com/sn10/SN10_PDA_Support.html Thanks, Best Regards, Dave "YO electric" |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Oudie wiring to SN10 | Tuno | Soaring | 23 | April 7th 11 08:28 AM |
ILEC SN10 release 2.35 | Dave Nadler | Soaring | 7 | March 27th 10 07:46 PM |
ILEC SN10 release 2.33 available | Dave Nadler | Soaring | 2 | July 24th 09 02:22 PM |
Ilec SN10 question | John Ferguson | Soaring | 3 | May 29th 07 05:11 AM |
FS - ILEC SN10 and Volkslogger | Dave Springford | Soaring | 0 | March 7th 05 12:43 AM |