If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
PIK 20 D Annual Inspection
PIK 20 D owners, can you give me some advice regarding how to
lubricate all controls? My rudder pedals are pretty stiff- I have to press pretty hard to move the rudder. Is there any way to lubricate it, or is that normal? Also, I have a problem with the horizontal stabilizer, it doesn't want to go on easy and then doesn't want to come off either. Is there any tricks to that? I have the wings going on and off pretty good, I keep a little space between the wing and fuselage to see if pins are aligning, and it works fine, but the horizontal stabilizer doesn't want to work well it even makes some cracking noises when I try to take it off. Service manual says to use grease press to lubricate, where are the fittings for that? Any help would be greatly appreciated. Thanks. Chris |
#2
|
|||
|
|||
PIK 20 D Annual Inspection
Get a Qualified engineer to inspect the PIK and don't
fly it until you have! |
#3
|
|||
|
|||
PIK 20 D Annual Inspection
On Sep 23, 10:06 am, Peter McKenzie-Brown
wrote: Get a Qualified engineer to inspect the PIK and don't fly it until you have! I will have A&P work on it,I just want to get as much info as I can. |
#4
|
|||
|
|||
PIK 20 D Annual Inspection
On Sep 22, 11:22?pm, wrote:
PIK 20 D owners, can you give me some advice regarding how to lubricate all controls? My rudder pedals are pretty stiff- I have to press pretty hard to move the rudder. Is there any way to lubricate it, or is that normal? Also, I have a problem with the horizontal stabilizer, it doesn't want to go on easy and then doesn't want to come off either. Is there any tricks to that? I have the wings going on and off pretty good, I keep a little space between the wing and fuselage to see if pins are aligning, and it works fine, but the horizontal stabilizer doesn't want to work well it even makes some cracking noises when I try to take it off. Service manual says to use grease press to lubricate, where are the fittings for that? Any help would be greatly appreciated. Thanks. Chris Where are you located? Robert Mudd Moriarty, New Mexico |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2006 Annual Inspection -- Complete | Jay Honeck | Owning | 12 | March 31st 06 03:27 AM |
2006 Annual -- My 8th "Owner-Assisted" Inspection | Jay Honeck | Owning | 19 | March 29th 06 01:28 AM |
Pre-buy Inspection | Jon Kraus | Owning | 49 | September 1st 04 12:42 PM |
Pre-buy Inspection | Jon Kraus | Piloting | 46 | September 1st 04 12:42 PM |
100 Hr Inspection | Scott D. | General Aviation | 6 | August 15th 04 01:03 AM |