If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
6005-T5 spar extrusion
Hello,
Does anybody have knowledge about using aluminum alloy 6005-T5 for a wing spar extrusion in replacement of 6061-T6 ? Apparently it has the same properties and is more extrudable. I am concerned by the "same properties", especially fatigue; but cannot find anything on the subject and I am completely ignorant myself. Thanks for any input ! J ean-Charles |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ASW-15B spar pins | [email protected] | Soaring | 1 | May 9th 06 12:46 AM |
Aluminum Extrusion for trailer ramp (USA) | ttaylor at cc.usu.edu | Soaring | 5 | June 28th 05 04:19 PM |
Spar workshop CD and DVD available | mat Redsell | Soaring | 0 | May 6th 04 03:52 PM |
spar varnish | Lou Parker | Home Built | 5 | May 3rd 04 04:19 PM |
Spar gluing | Lou Parker | Home Built | 26 | November 21st 03 08:29 PM |