![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Before I draw up my own, I'm wondering if anyone out there has a CAD
drawing for a DG instrument panel (non-motorglider, 300, 600, 800S, and possibly 100/200 panels should all be usable). I want to use an NC machine to cut a new panel face for my DG-600. If anyone has a drawing for any panel with correct standard instrument holes (altimeter, in particular), that would also be helpful... Thanks, Marc Note: remove REMOVE from email address... |
#2
|
|||
|
|||
![]() |
#3
|
|||
|
|||
![]()
That was easy...........any tips on where to dind a CAD drawinf of a
panel for Ventus C (lift up) ? Cheers Mark |
#4
|
|||
|
|||
![]()
JS wrote:
Try this one, Marc: http://www.dg-flugzeugbau.de/Data/instrument-panel.zip Thanks, I did have that, but I was hoping someone had something that they had verified was dimensionally accurate... Marc |
#5
|
|||
|
|||
![]() |
#6
|
|||
|
|||
![]()
Marc Ramsey wrote:
Before I draw up my own, I'm wondering if anyone out there has a CAD drawing for a DG instrument panel (non-motorglider, 300, 600, 800S, and possibly 100/200 panels should all be usable). I want to use an NC machine to cut a new panel face for my DG-600. If anyone has a drawing for any panel with correct standard instrument holes (altimeter, in particular), that would also be helpful... Thanks, Marc Marc, I've got a DG-600 non motor and a buddy of mine & I (more him than me) cut a panel on his CNC mill last season. We used I think .090 aluminum . We used the old fiberglass panel for a templett, cut the outline, used a hand brake to bend the lower mounting flange, the upper and side flanges to secure the pod cover. If there is enough interest he's willing to cut more of these panels and can cut to your specs. I had him cut 3 large holes, 80mm in the top row and 2 rows of 57mm below plus 4 circuit breaker holes and 1 master switch hole . you can contact me at r.barry at sbcglobal dot net. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
terminology questions: turtledeck? cantilever wing? | Ric | Home Built | 2 | September 13th 05 09:39 PM |
Instrument Checkride passed (Long) | Paul Folbrecht | Instrument Flight Rules | 10 | February 11th 05 02:41 AM |
Instrument panel labelling options | John Galban | Home Built | 12 | November 18th 04 10:42 PM |
Logging approaches | Ron Garrison | Instrument Flight Rules | 109 | March 2nd 04 05:54 PM |
PC flight simulators | Bjørnar Bolsøy | Military Aviation | 178 | December 14th 03 12:14 PM |