If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#9
|
|||
|
|||
How to Make a Poor Man's Spar Alignment Tool
You could be correct about the humidity changing the diameter of the dowel. However, a well seasoned and well sealed ash dowel may well not have that problem. Time till tell.
Again, this is a poor man's version of this tool. Easily finding the correct diameter metal or plastic/nylon rod, without machining capability, may be rather difficult. Maybe I should have called this the "poor CHEAP and EASY man's spar alignment tool"! My $0.02 (or ZWD 10,000,000,000). - John OHM Ω |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Alignment tool for spar pins | soartech[_2_] | Soaring | 5 | September 6th 12 05:39 PM |
Make yourself known by the market - Powerful marketing tool: | MarketingTool | Aviation Marketplace | 0 | December 13th 04 03:48 AM |
INS Alignment at Sea | Gary Watson | Naval Aviation | 5 | November 9th 03 05:14 PM |
INS Alignment at Sea | Larry | Naval Aviation | 28 | November 5th 03 12:58 PM |
Seneca De-Ice Brush Alignment Tool | John | Owning | 0 | September 9th 03 11:03 PM |