|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 6th 03, 09:11 PM
|
|||
|
|||
Using Balsa wood
In many area's on my wood structure it calls for a filler. Usually
spruce, but for no other reason but to fill a gap. These are not structural in the least, only to fill (i.e. on top of the spar a 1/4" strip of wood to keep the plywood skin from saging in between the wing ribs). Has anyone used Balsa wood to accomplish this to save on weight. There seems to be alot of little areas like this in my plans. Lou 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Right prop, wrong prop? Wood prop, metal prop? | Gus Rasch | Aerobatics | 1 | February 14th 08 10:18 PM |
| Metal Prop vs. Wood Prop | Larry Smith | Home Built | 21 | September 26th 03 07:45 PM |
| Wood questions - Public Lumber Company, determining species at the lumberyard | Corrie | Home Built | 17 | September 17th 03 06:51 PM |
| Direction of warping wood? | BllFs6 | Home Built | 2 | September 1st 03 10:52 AM |
Threaded Mode