|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 19th 03, 06:51 PM
|
|||
|
|||
HSI question?
I have an HSI (ARC IG-832) installed in the Aircraft. Just purchased a Century
1 Auto pilot. Can some A/P GURU tell me what two pins from the HSI I can drive the A/P with? I have a schematic of the HSI pinout if that helps. Any help is welcomed. Thanks in advance. Bill Oparowski 
|
|
#2
December 29th 03, 05:00 PM
|
|||
|
|||
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question: Researching Project | Tilt | Home Built | 21 | December 17th 03 02:39 PM |
| Tecumseh Engine Mounting Question | jlauer | Home Built | 7 | November 16th 03 01:51 AM |
| Question on Pulsejets/Ramjets??? | DarylG1532 | Home Built | 3 | August 16th 03 03:20 AM |
| Flap design question | Chris W | Home Built | 1 | August 4th 03 02:50 PM |
| Structural adhesive question | BD5ER | Home Built | 1 | August 3rd 03 06:03 AM |
Linear Mode
