|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 30th 10, 05:15 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Machine shop source needed/wanted
I'm looking for leads and or suggestions on where I might get some
dies made from hardened and ground steel. Think sheet metal bead roller dies, only about 3 inches long. I've never had anything like this made before and thought this might be a good place to start looking. The resulting tool will be aircraft related :-) ================== Leon 
|
|
#2
January 30th 10, 05:27 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Machine shop source needed/wanted
On Jan 30, 9:15*am, "
wrote: I'm looking for leads and or suggestions on where I might get some dies made from hardened and ground steel... I've had good luck with mfgquote.com. Put up an RFQ and someone will bite. Thanks, Bob K.
|
|
#3
January 31st 10, 07:17 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Machine shop source needed/wanted
On Jan 30, 7:15*am, "
wrote: I'm looking for leads and or suggestions on where I might get some dies made from hardened and ground steel. *Think sheet metal bead roller dies, only about 3 inches long. *I've never had anything like this made before and thought this might be a good place to start looking. *The resulting tool will be aircraft related :-) ================== Leon Try asking in Rec.crafts.metalworking Karl
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| flying brothers [7 of 26] "1903 machine in the shop.jpg" yEnc (1/1) | no name | Aviation Photos | 0 | August 22nd 09 06:36 AM |
| Machine shop information needed. | Dave[_16_] | Owning | 8 | October 14th 07 04:16 AM |
| Machine shop information needed. | Dave[_16_] | Home Built | 8 | October 14th 07 04:16 AM |
| Big chunk of 4130 -- source needed | Tom Young | Home Built | 12 | November 12th 04 03:18 AM |
| Pirep needed for Gulf Shores (JKA) Paint Shop | David | Owning | 0 | July 1st 04 02:12 PM |
Linear Mode
