Cobra Trailer Bearings

T@B trailers us the same axel. You can check with the US distributor for parts.

On Tuesday, July 10, 2018 at 5:46:44 PM UTC-4, Tim Taylor wrote:
T@B trailers us the same axel. You can check with the US distributor for parts.

Size:
OD= 60mm
ID = 30mm
width 37mm



I got mine at Advance Auto--- National/Moog 513116

or equivalents

NAPA GRW 120

SKF BA2Bo33313(c)

FAG 529891C

Thanks for the info - I ordered them through RMBEARINGS and they should arrive on Friday.

Great.
Be mindful of axle nut torque values. Too tight or too loose can waste a bearing very quickly. A spec sheet with the bearing, or online, can show the correct torque value.
Banging it on with an impact wrench is not correct.

Below from the Cobra manual, p9:
Jim

https://www.cobratrailer.com/wp-cont...ns_30-4-14.pdf

5.3.4 ALKO EURO Axles are equipped with maintanance free compact bearings

If necessary, adjust the axial play of the wheel bearing
- Remove the decoration and the wheel-hub cap.
- Remove the split-pin from the castellated wheel nut.
- Tighten the nut while spinning the wheel until a resistance is felt. If possible use a torque wrench
(50 Nm).
- Turn the castellated nut 1/12 of a turn (30°, see diagram 1) then turn back to the next pin
alignment position.
Axial play to 0.05 mm is acceptable.

Overtightening will cause bearing damage
- Check grease for quantity and condition, top-off or renew, if necessary
- Grease type for wheel bearings: Multi-purpose grease DIN 51825 KTA3K
- Replace wheel hub caps