If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Speakin' of Round Engines...
This might fly under the right conditions...
JT |
#2
|
|||
|
|||
Speakin' of Round Engines...
Grumpy AuContraire wrote:
This might fly under the right conditions... JT ------------------------------------------------------------------------ Something throbbing between the thighs! Ricardo -- "Quick to judge, quick to anger, slow to understand Ignorance and prejudice, and fear, walk hand in hand ..." |
#3
|
|||
|
|||
Speakin' of Round Engines...
This might fly under the right conditions...
Speaking as a former round engine operator and current sportbike rider..... I'm thinking that thing is WAY dangerous. Imagine how oily the back tire must get. OL |
#4
|
|||
|
|||
Speakin' of Round Engines...
Overlord wrote:
This might fly under the right conditions... Speaking as a former round engine operator and current sportbike rider..... I'm thinking that thing is WAY dangerous. Imagine how oily the back tire must get. OL Must also have curious gyroscopic effects. -- Cheers Dave Kearton |
#5
|
|||
|
|||
Speakin' of Round Engines...
"Grumpy AuContraire" wrote in message ... This might fly under the right conditions... That is wrong on so many levels... Luke |
#6
|
|||
|
|||
Speakin' of Round Engines...
"Grumpy AuContraire" wrote:
This might fly under the right conditions... I'm thinking "photoshopped," as in "How is the front yoke attached to the rest of the machine" and "Why does the rear edge of the left shaft look so uneven where it meets the engine?" not to mention "What does that engine do for cooling?" and "Will the tank run dry before engine heat causes the fuel to boil?" and "Maybe it's my eyesight, but why don't I see a wiring harness?" --Bill Thompson |
#7
|
|||
|
|||
Speakin' of Round Engines...
Seems to be a true story - found this link that may be of interest
http://thekneeslider.com/archives/20...ed-motorcycle/ __________________________________________________ ____ There is always a lot to be thankful for, if you take the time to look. For example, I'm sitting here thinking how nice it is that wrinkles don't hurt |
#8
|
|||
|
|||
Speakin' of Round Engines...
"TACAN" wrote (in part):
Seems to be a true story - found this link that may be of interest http://thekneeslider.com/archives/20...ed-motorcycle/ That's not the mo'bike in this thread. At least this engine is orientated for cooling. Same can't be said for the rider, tho'. -- Mike Mackenzie (AVCOM Services) Brisbane, AUSTRALIA Remove "XYZ" from the "Reply to" address when responding by email. |
#9
|
|||
|
|||
Speakin' of Round Engines...
"Grumpy AuContraire" wrote in message ... This might fly under the right conditions... JT For everyones information, that bike is featured on the following website. http://www.jrlcycles.com/ HTH Jeff C. Atherton QLD Australia |
#10
|
|||
|
|||
Speakin' of Round Engines...
"TACAN" wrote in message
... Seems to be a true story - found this link that may be of interest http://thekneeslider.com/archives/20...ered-motorcycl e/ Holy snappin' arseholes, Batman! -- Alan Erskine |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Round Engines | Big John | Piloting | 80 | January 27th 06 03:29 AM |
Round Engines | Voxpopuli | Naval Aviation | 16 | May 31st 05 06:48 PM |
Next Round Of Base Closures | Slapshot | Military Aviation | 8 | February 26th 04 02:58 PM |