If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#25
|
|||
|
|||
Wedekind Sleeve Source?
On Tuesday, March 8, 2016 at 9:00:10 AM UTC-5, Vernon Brown wrote:
At 12:26 08 March 2016, Tango Eight wrote: On Tuesday, March 8, 2016 at 5:17:58 AM UTC-5, Vernon Brown wrote: So I started to cleaned each ball end then lubricate with thin oil (WD40) Way off track, but may I drop a tip here? Vernon: WD-40 is fish oil. It's a great water dispersant (the "WD" in WD-40), but it has lousy oxidation stability and gets gummy. Use Break Free CLP. best, Evan Ludeman Thanks Evan, didn't know WD40 was fish oil, gumming up should not a problem if controls are cleaned before every rigging, which I did, but useful info nerveless, which will be useful to others. Sold my Cirrus about 12 years ago, had an LS8/18 for a while, now I have an LS6c 17.5 both auto connects. Vernon I've always had great luck with Marvel Mystery Oil. It was the club solution for just about all spring lubing at CCSC and worked great even at super cold wave temps. FWIW |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wedekind sleeve | Hartley Falbaum[_2_] | Soaring | 4 | February 5th 14 12:54 PM |
Wedekind sleeve for Std Cirrus | John Galloway | Soaring | 8 | July 9th 13 02:15 PM |
pvc tubing/sleeve source? | Jim Burns | Owning | 4 | September 28th 06 03:36 AM |
pvc tubing/sleeve source? | Jim Burns | Home Built | 4 | September 28th 06 03:36 AM |
Source for Wedekind sleeves - AS-W20a | Mark Grubb | Soaring | 7 | April 6th 04 08:19 PM |