|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 9th 10, 06:34 PM
posted to rec.aviation.soaring
|
|||
|
|||
Remove layer of cloth/Gelcoat
I know it can be done.
On an ASW-15, the first layer of cloth was pulled off the wings and a fresh layer of cloth was applied. It worked out well. The naked surface is rough enough to allow good bond of new layer. GA 
|
|
#2
February 9th 10, 07:39 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
Remove layer of cloth/Gelcoat
On Feb 9, 1:34*pm, glider wrote:
I know it can be done. *On an ASW-15, the first layer of cloth was pulled off the wings and a fresh layer of cloth was applied. It worked out well. The naked surface is rough enough to allow good bond of new layer. *GA Schleicher manual mentions this in maintenance instructions- paint cracks associated with damage that goes thru gelcoat into top layer of glass. UH
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gelcoat sag? | [email protected] | Soaring | 10 | December 17th 07 08:07 PM |
| composite using aluminum windowscreen layer | Allan Morrison | Home Built | 4 | January 27th 05 01:19 PM |
| F104- Boundary Layer Control | Scet | Military Aviation | 7 | August 27th 04 09:48 AM |
| Descending through a thin icing layer | Wyatt Emmerich | Instrument Flight Rules | 70 | December 31st 03 05:17 AM |
| Ferro gelcoat | Basil Fairston | Soaring | 0 | December 16th 03 08:34 AM |
Linear Mode
