|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 24th 05, 02:50 AM
|
|||
|
|||
Honeywell KFC225 autopilot roll servo failure
Peter wrote: I've just had my 6th failure of the roll servo, since 2002. This time I got a video of it, showing that the power-up tests pass even with a dead roll servo: http://www.zen74158.zen.co.uk/misc-f...ure-2005-1.mpg Evidently Honeywell have not fixed this - even though the KFC225 has failed on every aircraft whose owner I have managed to contact over the last few years. Can anyone offer me any info on this servo, e.g. schematics? I already have the KFC225 main unit schematics so I have the interface (which is very simple). Peter. -- Did you contact Honeywell in Phoenix Arizona? Mark 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Honeywell KFC225 autopilot roll servo failure | [email protected] | Instrument Flight Rules | 19 | September 28th 05 06:12 AM |
| Honeywell KFC225 autopilot roll servo failure | [email protected] | General Aviation | 14 | September 28th 05 06:12 AM |
| slow roll in a super decathlon | Nobody | Aerobatics | 4 | August 24th 05 02:36 AM |
| TSA requirement of Security Awareness Training | dancingstar | Piloting | 3 | October 5th 04 02:17 AM |
| ALTRAK pitch system flight report | optics student | Home Built | 2 | September 21st 03 11:49 PM |
Threaded Mode