|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 12th 08, 10:49 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
CNC lathe conversion
Hello,
in my wich list about machining (for homebuilt), I want convert a lathe to a CNC lathe (standard asian 9x20 like Grizzly 4000). Is this guy still in business? http://www.thompsonmachine.net/9x20kit.htm I never have any answer when I sent Emails. thanks -- Minicab F-PRAZ Philippe Vessaire Ò¿Ó¬ ** Posted from http://www.teranews.com ** 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "...but I don't have a lathe." | [email protected] | Home Built | 47 | September 20th 08 12:53 AM |
| Kyle gets the mini lathe home.... | Stealth Pilot[_2_] | Home Built | 20 | August 24th 08 02:08 AM |
| But I don't have a lathe - - Part II | [email protected] | Home Built | 6 | March 21st 06 07:32 PM |
| Lathe, drillpress, milling machine available, but..... | Michael Horowitz | Home Built | 47 | February 25th 06 03:36 PM |
| Lathe Help | Bruce A. Frank | Home Built | 15 | February 7th 04 09:05 AM |
Linear Mode
