If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Expanding a bronze bushing?
I have a small bronze bushing whose OD I'd like to expand slightly so
it fits the ID of a tube. I seem to recall there was a way to expand the OD slightly with something like a knurling tool. Does that sound familiar? Is there an easy way to do this? - Mike |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
?replace bushing on compressor wheels? | mhorowit | Home Built | 4 | September 22nd 08 03:43 AM |
Expanding my flying comfort zone (long) | Ron Lee[_2_] | Piloting | 2 | December 8th 07 03:02 AM |
Enlarging a bushing hole? | Michael Horowitz | Home Built | 18 | September 17th 07 11:57 AM |
(CNN & AP) U.N: Iran expanding rather than freezing nuclear program | AirRaid[_3_] | Naval Aviation | 3 | February 26th 07 06:49 PM |
Rubber Bushing Replacement | Boelkowj | Home Built | 8 | December 12th 03 12:45 AM |