|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#8
October 18th 17, 12:33 AM
posted to rec.aviation.soaring
|
|||
|
|||
air extractor for asw19 and asw20
I didn’t cut the holes, but mine has a fold down wood bulkhead with a pretty gap (about 1/2 inch) around the perimeter. That gap was large enough that I though I’d give it a try before cutting the holes. I was happy with the result, so I’ll probaby not cut the holes. The fiberglass bulkhead has a tighter fit, so you may ne d the holes.
John 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ASW19 for sale | [email protected] | Soaring | 2 | September 12th 16 10:07 PM |
| ASW19 Inner Tube | [email protected] | Soaring | 1 | September 21st 15 03:54 PM |
| Air extractor for sustainer and motor gliders? | [email protected] | Soaring | 12 | August 26th 15 07:41 AM |
| Air Extractor: Better than a Plastic Jesus? | [email protected] | Soaring | 23 | December 18th 13 08:48 AM |
| asw19 airbrake kit | steve[_2_] | Soaring | 2 | April 7th 11 08:32 PM |
Threaded Mode