|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 10th 07, 05:29 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
OSH ...aluminum needs polishing. HELP!!
What are the wings bonded with? Will they safely withstand the internal
temperatures they'll see in bare aluminum finish? We didn't talk specifics when I was at the hangar, other than - when the ION was engineered (by people who know this stuff), that was very much factored in. The rest of the plane is composite, just the (removable) wings are aluminum. Oh, and the rudder(s) and elevator, they're aluminum too. http://www.ionaircraft.com/Toucan.jpg "Toucan" needs to be updated to show three (green) aluminum control surfaces on the empennage. Montblack 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| OSH ...aluminum needs polishing. HELP!! | Montblack | Home Built | 16 | May 16th 07 02:37 PM |
| OSH ...aluminum needs polishing. HELP!! | Montblack | Piloting | 5 | May 9th 07 04:18 PM |
| OSH ...aluminum needs polishing. HELP!! | Montblack | Owning | 5 | May 9th 07 04:18 PM |
| aluminum rib, aluminum spar, holes drilled but screws broken off | jls | Home Built | 13 | January 3rd 07 08:06 AM |
| Polishing a Blanik L-13? | Papa3 | Soaring | 12 | April 21st 06 07:10 PM |
Linear Mode
