|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#14
March 12th 05, 04:18 AM
|
|||
|
|||
"Morgans" wrote in message
... "mindenpilot" wrote We do all kinds of little tricks like putting a notch in the crankshaft to use as a phase reference. Then we can determine at what point in the cycle an anomaly occurs, which can lead to different diagnoses. How does the notch help in telling the rotational position? -- Jim in NC It takes a little nick out your finger as it goes by? Rich "Ow ow ow ow owow ow ow ow ow owow" S. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vibration Monitor (Hyde, Wanttaja?) | RST Engineering | Home Built | 71 | April 4th 05 04:44 PM |
| Pinging Ron Wanttaja - "Unporting?" | Bob Chilcoat | Home Built | 13 | November 24th 04 07:28 PM |
| Vibration Testing | Jim Weir | Home Built | 20 | October 10th 04 07:22 AM |
| Vibration Testing | Jim Weir | Owning | 21 | October 10th 04 07:22 AM |
| Survey - 3 blade prop conversion- Cockpit vibration, happy or not | Fly | Owning | 20 | June 30th 04 05:32 PM |
Threaded Mode