If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Sloshing compound is failing
Jim: I don't believe it is the MEK that is so toxic. I was an organic
chemist for many years. MEK evaporates very quickly and doesn't get past your skin surface. MEK which may have toluene in it is a different story. Yes aromatic benzene/toluene is quite toxic. Larry |
#12
|
|||
|
|||
Sloshing compound is failing
"Larry" wrote in message ups.com... Jim: I don't believe it is the MEK that is so toxic. I was an organic chemist for many years. MEK evaporates very quickly and doesn't get past your skin surface. MEK which may have toluene in it is a different story. Yes aromatic benzene/toluene is quite toxic. Well, if you are to believe the three websites I googled about the chemical properties, it its. Man, anything that dissolves stuff so quickly and completely as MEK, has GOT to be nasty, bad for you stuff! G Do a little googling, and report back, as to whether they are full of sh*t, and if so, why, with some backup references as to why, of course! ;-) -- Jim in NC |
#13
|
|||
|
|||
Sloshing compound is failing
Don't use Randolph again. Ever. Use PRC 1005L Buna-N, available from Spruce.
The sealant is diluted in MEK, you pour, slosh, drain excess, let dry and you're done, and its impervious to any fuel additives. I seem to remember the Randolph site says that 912 is no longer available. I also can't find on the 'Spruce site where PRC 1005L Buna-N is at all alcohol resistant. That said, has anyone tried that POR-15 stuff? Or the 'alcohol resistant' sealer on Hirsch Auto's site? I'm looking since my RV tanks are over 16 years old and starting to seep. Jim |
#14
|
|||
|
|||
Sloshing compound is failing
|
#15
|
|||
|
|||
Sloshing compound is failing
Larry, MEK is very nasty stuff, does get through the skin.
http://www.ilo.org/public/english/pr...1/icsc0179.htm "Larry" wrote in message ups.com... Jim: I don't believe it is the MEK that is so toxic. I was an organic chemist for many years. MEK evaporates very quickly and doesn't get past your skin surface. MEK which may have toluene in it is a different story. Yes aromatic benzene/toluene is quite toxic. Larry |
#16
|
|||
|
|||
Sloshing compound is failing
Larry wrote: Jim: I don't believe it is the MEK that is so toxic. I was an organic chemist for many years. MEK evaporates very quickly and doesn't get past your skin surface. Uh, it gets past you rskin if it gets inhaled, right? There are lots of places where the MSDS is posted, usually in .pdf format: http://www.palomar.edu/ehs/Chemistry...L%20KETONE.pdf -- FF |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Peel plying and compound curvature | [email protected] | Home Built | 3 | August 10th 05 01:32 AM |
compound curves in plywood | BA-100 | Home Built | 58 | April 13th 05 05:29 AM |
Nut/thread securing compound | nauga | Home Built | 7 | April 22nd 04 07:56 AM |
Cirrus' "Failing Instruments In Rapid Succession" | Marco Leon | Piloting | 21 | April 17th 04 07:47 PM |
Randolph Wing Walk Compound | Larryskydives | Owning | 7 | March 7th 04 09:44 PM |