If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Yet Another wing Refinishing question
Hello All,
As the proud custodian of a schempp-Hirth SHK-1, I would like to know if anybody has any recomendations for a filler primer suitable for reprofiling. I have read most of the posts which came up after searching this forum. Was going to use simtec 2081, however, sombody reported it clogs paper? Somone else used Sikkens Colorbuild. Whatever I use it will be applied to a wood surface previously prepped with randolph ev-400 catalysed epoxy varnish, and topcoated with randolph ranathane catalysed paint. I have a lot of experience with automotive coatings, and am looking for a material at least as good as the original product. I.E ease of sanding and durability. Thanks, Scott. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wing Leading Edge Refinishing | Jan Eldem[_2_] | Soaring | 4 | June 17th 08 02:40 PM |
Wing walk ply question. | Mustardbuilder | Home Built | 20 | January 28th 07 10:16 AM |
Rotor-wing question | D. Andrews | Rotorcraft | 8 | October 2nd 05 11:43 AM |
Folded wing tip question | a425couple | Naval Aviation | 35 | May 12th 05 11:40 PM |
Older glass glider refinishing question | Gus Rasch | Soaring | 6 | November 10th 03 12:18 AM |