|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 16th 19, 03:46 PM
posted to rec.aviation.soaring
|
|||
|
|||
Vertical Card Compass Interference?
Vertical Card Compass Interference?
I'm installing an LXNAV S100 top center in my panel with FLARM, ADS-B and GPS antennas at back/top of instrument shroud. I have a PAI-700 Vertical Card Compass mounted now on top of shroud about 2/3 back from front. As it sits now it would be only ~4" from antennas at rear. If you go by manufacturers' recommendations on anything electrical everything should be at least 3 feet from everything else  . 1 - Does anyone have any empirical evidence of antenna interference specifically from this type of compass? I could move the compass forward but it gets closer to the S100. 2 - Does anyone have any empirical evidence of Vario/Flight Computer interference from this type of compass? Note: I am less concerned about the effect on the compass vs the compass effect on the other stuff Thanks all. Curt - 95 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vertical Card Compass? | Bubba[_2_] | Owning | 10 | April 2nd 07 03:31 PM |
| Vertical card compass? | Bubba[_2_] | Home Built | 1 | March 31st 07 12:49 AM |
| Vertical Card Compass? | Bubba[_2_] | Products | 0 | March 30th 07 06:58 PM |
| Vertical Card Compass | Bubba[_2_] | General Aviation | 0 | March 30th 07 06:56 PM |
| Vertical Card Compass? | Bubba[_2_] | Aviation Marketplace | 0 | March 30th 07 06:56 PM |
Threaded Mode