![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#9
|
|||
|
|||
![]() "John Smith" wrote in message ... Tman wrote: There will come the day when you need full power for the go-around. Too silly if you then have the carb heat on. Then again, how hard is it to shove in the carb heat knob while you advance the throttle in a Cessna? They are right next to each other. I have always just pushed in the carb heat handle at the same time as I advance the throttle, not that difficult to do, even using the same hand. Randy L. -- Remember: Any landing that you can walk away from, is a landing that you can be fined, sued, or prosecuted for. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Carb Heat | [email protected] | Rotorcraft | 11 | April 30th 07 06:34 PM |
Carb Heat | vlado | Piloting | 9 | January 22nd 07 03:08 PM |
Use of Carb Heat | John Kirksey | Piloting | 4 | November 30th 04 07:26 PM |
Carb heat specs? | Rich S. | Home Built | 2 | November 13th 04 04:39 PM |
Cherokee Carb Heat. | Greg Esres | Piloting | 15 | July 29th 03 02:25 PM |