|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 31st 20, 08:36 PM
posted to rec.aviation.soaring
|
|||
|
|||
Ventus2 Airworthiness Directive - flaperon drive
This instructions for this AD refer to a Feb 2020 Maintenance Manual
amendment, in case an access hole has to be cut. Has anyone had sight of this amendment yet? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Std. Airworthiness for ASK 21B | [email protected] | Soaring | 11 | March 27th 19 09:14 PM |
| Source for aileron/flaperon linkage fairings or covers? | Bret Hess | Soaring | 3 | September 7th 18 11:36 PM |
| stemme flaperon mix control | bjarthur | Soaring | 6 | October 22nd 08 02:23 AM |
| LS3 flaperon gap seal template needed | Birdbones | Soaring | 2 | May 14th 05 12:46 AM |
Linear Mode
