If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#7
|
|||
|
|||
vinyl wrap
On Friday, October 5, 2018 at 5:58:58 PM UTC-5, wrote:
On Friday, October 5, 2018 at 6:25:51 PM UTC-4, wrote: That said just putting over old cracked gelcoat would be a poor decision. UH Why? Not challenging what you say, UH, just want to understand what the issues would be. I can guess some, but I would love to hear yours, much more of an experience base than mine.... Cheers, J6 1- Unless enough of the existing finish is removed, there likely will be mass balance issues. 2- If failing finish is not removed, the failure of the finish will continue. It is cracking because it is old and brittle and shrinking. 3- Crappy under surface will almost certainly show through unless sanded smooth and flat. "There has to be an easier way". UH Also, How would a cosmetically flawless Wrap be perceived by an inspector, or a potential buyer? In this world you can have Good, Fast, Cheap, Pick any two. Scott |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Vinyl Numbers | [email protected] | Soaring | 10 | June 19th 18 11:03 PM |
Applying Vinyl Contest numbers..... | Gary Adams | Soaring | 0 | May 11th 12 10:13 PM |
Removing vinyl letters | Gary[_5_] | Soaring | 7 | December 31st 11 06:10 PM |
vinyl trim source | Brad[_2_] | Soaring | 3 | March 23rd 10 05:02 AM |
Plastic/Vinyl letters | Mel Dawson | Soaring | 23 | February 18th 06 11:46 PM |