If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
F16 for sale
Check out:
http://cgi.ebay.com/ebaymotors/F16-A... 194631QQrdZ1 I've always wanted one. Do you think it would fit in my hangar? |
#2
|
|||
|
|||
Wonder what a typical annual would cost.
|
#3
|
|||
|
|||
"Dan Luke" writes:
Wonder what a typical annual would cost. "Daily" not annual... What is it...20 hours of maint for every hour of flight? -- A host is a host from coast to & no one will talk to a host that's close........[v].(301) 56-LINUX Unless the host (that isn't close).........................pob 1433 is busy, hung or dead....................................20915-1433 |
#4
|
|||
|
|||
I read somewhere it costs $50,000 to prep a fighter jet for flight.
"David Lesher" wrote in message ... "Daily" not annual... What is it...20 hours of maint for every hour of flight? |
#5
|
|||
|
|||
Quote:
|
#6
|
|||
|
|||
Doug wrote:
Check out: http://cgi.ebay.com/ebaymotors/F16-A... 194631QQrdZ1 I've always wanted one. Do you think it would fit in my hangar? If you have $14M, then you're my best friend! :-) |
#7
|
|||
|
|||
"Doug" wrote in message oups.com... Check out: http://cgi.ebay.com/ebaymotors/F16-A... 194631QQrdZ1 I've always wanted one. Do you think it would fit in my hangar? I wonder what the chances are of getting it licensed. |
#8
|
|||
|
|||
A few years ago I was looking at buying a Mig 15 or 21. There was a site on
the net that advertised them for sale for 20 - 50K depending on the model. The also had a price/hour spreadsheet. For the Mig 15 the cost was about 1K per hour and the 21 was about 1.5K per hour. You could give me one and I still could not afford it. "John Kunkel" wrote in message ... "Doug" wrote in message oups.com... Check out: http://cgi.ebay.com/ebaymotors/F16-A... 194631QQrdZ1 I've always wanted one. Do you think it would fit in my hangar? I wonder what the chances are of getting it licensed. |
Thread Tools | |
Display Modes | |
|
|