If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Rocket Man VW Heads... What alloy?
Okay, then YOU name the damn things!
Right now I got a couple questions: VW heads are nearly pure aluminum. I've got a pile of the things but odds are, every single one of them is worth a $25 bill... or will be. Point is, I don't much care for the idea of cutting them and melting them down. When I make something SERIOUS out of aluminum I usually use old pistons, which is a pretty hard alloy with a MUCH lower heat-transfer ability than VW heads. So what's a good alloy? Ideally, something cheap & commonly available (and doesn't say 'Coors'!) ------------------------------------------------------------------------------------------------------- Second question: Rocket Man heads needum' rockers. I wuz thinking of using Chebby 1.3 break-in rockers. Any better ideas? (Or rather, any ideas at all?) ------------------------------------------------------------------------------------------------------- -Bob |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Need help with a rocket motor ID unk-rocket- | Dave Kearton | Aviation Photos | 0 | February 2nd 07 08:09 AM |
Traffic Heads-up | [email protected] | Products | 1 | July 7th 05 04:50 PM |
1966 Cessna 172 Control Yokes --- What Alloy? | jls | Home Built | 0 | November 4th 04 05:02 PM |
TWO EXTREMELY RARE ROCKET BOOKS ON EBAY - INCREDIBLE ROCKET HISTORY! | TruthReigns | Military Aviation | 0 | July 10th 04 11:54 AM |
SCAM - Heads up | DaveSpringford | Soaring | 0 | December 4th 03 11:13 PM |