|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 17th 05, 02:54 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Refinishing wooden prop
I have an otherwise airworthy wooden prop that could use refinishing and
I'm seeking advice on how to do the refinish. What's the best way to remove the old finish? Will strippers cause the prop to delaminate? What's the best or most commonly used finish? Thanks 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| IVO props... comments.. | Dave S | Home Built | 16 | December 6th 03 11:43 PM |
| FS: 114 inch wooden prop | minot piper e | Aviation Marketplace | 0 | November 21st 03 04:01 AM |
| Wooden Prop | minot piper e | Home Built | 1 | October 26th 03 11:39 PM |
| Wooden Prop | Brian O'Sullivan | Aviation Marketplace | 3 | October 13th 03 02:34 PM |
| Wooden Prop | Ian Donaldson | Aviation Marketplace | 0 | October 13th 03 11:30 AM |
Threaded Mode