|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 3rd 17, 01:38 PM
posted to rec.aviation.soaring
|
|||
|
|||
Bungee Material for Landing Gear and Engine Bay Doors
I am looking for a source for bungee material for my landing gear and engine bay doors (ASH-26E). The original (German-sourced?) bungee is about 5 mm diameter and stretches to about twice the rested length. The 3/16 inch USA-sourced material I have been able to find (McMaster-Carr, etc.) doesn't stretch quite as much, about 75% rested length. Since the adjustment on the '26's engine bay doors is quite critical, I really would like to find the original (German-sourced?) bungee material with more stretch. Anyone know where I can get some?
Thanks, Jim 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| gear doors | hoss | Soaring | 5 | October 21st 10 02:06 AM |
| LS-6 Gear Doors FOR SALE | John Bojack[_2_] | Soaring | 0 | May 5th 09 02:58 AM |
| sealing landing gear doors ...... | Ron Gleason | Soaring | 11 | April 23rd 09 02:43 PM |
| FOX NEWS ALERT - Van Nuys Twin Engine Cessna landing with no nose gear | Darkwing | Piloting | 12 | December 8th 08 09:16 PM |
| Navy? C2/COD makes single engine, gear up landing. | Dave S | Piloting | 20 | August 20th 05 10:27 AM |
Threaded Mode