A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups » Piloting
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Mounting 396



 
 
Thread Tools Display Modes
  #1  
Old August 14th 07, 03:55 PM posted to rec.aviation.piloting,rec.aviation.owning
Paul kgyy
external usenet poster
 
Posts: 283
Default Mounting 396

I have received the Garmin GPSMAP 396 that I ordered at OSH and am now
trying to figure out how to mount it securely in the airplane (Piper
Arrow)
1 I want to be able to use it out of the airplane occasionally.
2 Experimenting with it at home, it appears to me that the font size
on both screen and controls requires that it be within 2 feet of my
eyes. This seems to eliminate the Airgizmos mount in the radio stack
2 position, also the passenger yoke position.
3 This seems to leave either top of the glareshield, pilot yoke, or
suction cup on left windshield.
a. Glareshield location too high - impairs visibility
b. Yoke
(1) concerned about loose wires impairing yoke movement
(2) have to find another place for my approach plates
and time (currently both on yoke mount)
c. Suction Cup mount
This seems the best option in many ways, except that the
suction cups fall off occasionally, which is a safety hazard.

Other opinions/ideas?

  #2  
Old August 14th 07, 04:50 PM posted to rec.aviation.piloting,rec.aviation.owning
john smith
external usenet poster
 
Posts: 1,446
Default Mounting 396



Paul kgyy wrote:
c. Suction Cup mount
This seems the best option in many ways, except that the
suction cups fall off occasionally, which is a safety hazard.


Do you have the long- or short-arm between the 396 and the suction cup?
If you have the long one, it may have too great a moment for the suction
cup to hold. I have the short one, and have only had it come off after
sitting in the sun on the ground for a couple of hours.
  #3  
Old August 14th 07, 06:08 PM posted to rec.aviation.piloting,rec.aviation.owning
Paul kgyy
external usenet poster
 
Posts: 283
Default Mounting 396


Do you have the long- or short-arm between the 396 and the suction cup?
If you have the long one, it may have too great a moment for the suction
cup to hold. I have the short one, and have only had it come off after
sitting in the sun on the ground for a couple of hours.


I haven't actually bought the suction cup yet, though I do have an
older one that I may try to adapt. I agree, the shorter, the better.
I think the one I have is maybe 6-8".

  #4  
Old August 14th 07, 11:25 PM posted to rec.aviation.piloting,rec.aviation.owning
Dan Luke[_2_]
external usenet poster
 
Posts: 713
Default Mounting 396


"Paul kgyy" wrote:

I have received the Garmin GPSMAP 396 that I ordered at OSH and am now
trying to figure out how to mount it securely in the airplane (Piper
Arrow)



The yoke mount worked best for me in my 172RG.

Advantages:

o Easy to include in your instrument scan.

o Close at hand for button pushing.

o Positioned just right for bifocals/reading glasses.

o Right where it needs to be for using the faux panel if you lose your
gyros.

Disadvantages:

o You have to find somewhere else to hold approach plates.

o Wires have to be routed down the yoke shaft.

Bottom line, I found the yoke mount the handy had no problems with it.

--
Dan
T-182T at BFM


  #5  
Old August 14th 07, 11:38 PM posted to rec.aviation.piloting,rec.aviation.owning
Dan Luke[_2_]
external usenet poster
 
Posts: 713
Default Mounting 396


Bottom line, I found the yoke mount handy and had no problems with it.



Fire the copy editor.


  #6  
Old August 15th 07, 01:29 AM posted to rec.aviation.piloting,rec.aviation.owning
Andrew Gideon[_2_]
external usenet poster
 
Posts: 23
Default Mounting 396

On Tue, 14 Aug 2007 17:25:06 -0500, Dan Luke wrote:

o You have to find somewhere else to hold approach plates.


Where?

- Andrew

  #7  
Old August 15th 07, 01:45 AM posted to rec.aviation.piloting,rec.aviation.owning
Paul kgyy
external usenet poster
 
Posts: 283
Default Mounting 396

On Aug 14, 5:38 pm, "Dan Luke" wrote:
Bottom line, I found the yoke mount handy and had no problems with it.




How did you do the wiring to provide free movement of the yoke?

  #8  
Old August 15th 07, 12:37 PM posted to rec.aviation.piloting,rec.aviation.owning
Dan Luke[_2_]
external usenet poster
 
Posts: 713
Default Mounting 396


"Paul kgyy" wrote:

How did you do the wiring to provide free movement of the yoke?



Under the yoke shaft I attached an adhesive tie-wrap clip to the panel.
Before I tie-wrapped the cables to the clip, I pulled the yoke out to its full
aft travel. The cables then trailed below the yoke shaft along with the PTT
cable. This setup was unobtrusive and caused no interference problems with
the yoke.

--
Dan
T-182T at BFM


  #9  
Old August 15th 07, 12:48 PM posted to rec.aviation.piloting,rec.aviation.owning
Dan Luke[_2_]
external usenet poster
 
Posts: 713
Default Mounting 396


"Andrew Gideon" wrote:

o You have to find somewhere else to hold approach plates.


Where?


I kept them on a clipboard in my lap. The clipboard also held a letter sized
sheet with my flightplan and space to copy clearances.

I still use this setup, even though I no longer need a yoke mounted GPS and
have a chart clip available on the yoke.

--
Dan
T-182T at BFM


  #10  
Old August 15th 07, 05:46 PM posted to rec.aviation.piloting,rec.aviation.owning
Jonathan Goodish
external usenet poster
 
Posts: 190
Default Mounting 396

In article .com,
Paul kgyy wrote:

I have received the Garmin GPSMAP 396 that I ordered at OSH and am now
trying to figure out how to mount it securely in the airplane (Piper
Other opinions/ideas?


When I used AnywhereMap, I had the PDA on a suction cup mount,
positioned on the left-hand front window. It was positioned so that the
PDA appeared just below the glare shield. It worked well, but mainly
because I could remove the PDA from the mount for data entry.
Unfortunately, the 396 can't be removed from the mount as quickly or
easily, which would require operating the unit with my left hand, or
reaching across with my right hand. Not an ideal situation.

For the 396, I've elected to keep it on a yoke mount. I believe that
there are some advantages to the yoke mount, with one being easy of use
and easy visibility.

If you elect to try the suction cup mount, I highly recommend the
G-Force mount available he http://www.propellerheadpilot.com/

I left it on almost continuously, and it NEVER came loose on its own.



JKG
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Mounting cameras keithw Soaring 2 December 3rd 05 06:02 PM
GPS mounting bracket Michael Ware Owning 3 November 6th 05 12:30 AM
PDA mounting alternatives Jack Glendening Soaring 15 October 14th 05 08:03 PM
Mounting my GPS Charles Talleyrand Owning 8 November 19th 03 12:51 PM
Mounting my GPS Charles Talleyrand Piloting 8 November 19th 03 12:51 PM


All times are GMT +1. The time now is 01:45 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AviationBanter.
The comments are property of their posters.