If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Bending sheet stock
I ordered some .020 4130 sheet about12x36
I notice the writing on the sheet runs parallel to the 12" edge. Do I understand then that the grain of the steel is parallel to the 12"edge? If I plan on bending this sheet, is there harm in bending across the grain? - Mike |
#2
|
|||
|
|||
Bending sheet stock
Michael Horowitz wrote: I ordered some .020 4130 sheet about12x36 I notice the writing on the sheet runs parallel to the 12" edge. Do I understand then that the grain of the steel is parallel to the 12"edge? If I plan on bending this sheet, is there harm in bending across the grain? - Mike Other than the parts cracking, no problem. Look at the metal. You can SEE the grain. Richard |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FS: 1930's Space Exploration Un-Cut Tatoo Sheet | J.R. Sinclair | Aviation Marketplace | 0 | June 7th 04 06:28 AM |
Building the Po' Boy Bending Brake | Veeduber | Home Built | 14 | March 1st 04 06:15 PM |
4130 Chromaloy Sheet Availability | c hinds | Home Built | 1 | January 24th 04 04:17 AM |