If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Lathe, drillpress, milling machine available, but.....
The local EAA chapter has a lathe, drillpress, milling machine, etc
set up in the back of the chapter house. As far as I can tell, the lathe hasn't been used in a while. When I asked, someone rightly replied they were concerned someone might hurt themselves using the lathe. Having had some training with a lathe, I recognize that danger, but there should be a way for the Chapter to feel comfortable allowing use of the lathe. A training program would be ideal Has anyone else been faced with this situation and how did it get solved? - MIke |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
"...but I don't have a lathe." | [email protected] | Home Built | 47 | September 20th 08 12:53 AM |
Democracy Expires | Grantland | Military Aviation | 14 | March 8th 04 04:54 AM |
Lathe Help | Bruce A. Frank | Home Built | 15 | February 7th 04 09:05 AM |
Fess up! Simming...and the machine..... | Dr. Anthony J. Lomenzo | Simulators | 1 | November 28th 03 05:31 PM |
Machine Tool Co. Bankruptcy Sends Ripple Through JSF Program | huuto | Military Aviation | 3 | July 29th 03 05:59 AM |