If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
A friend of mine is building a Legacy and has a question....
Hey, ask anyone on the rec homebuilt group if they've ever built any
Lancairs and then ask them if they used a 1 degree toe-in on the main landing gear for the 320, the Lancair 4 or the Legacy. I test drove mine today and almost lost control of it in yaw on the runway because it's dead nuts on center with the mains. No where in the manual does it say you need toe-in, but I have a sneaking hunch that I need a half degree on each main to keep it from being divergent. I'm going to just do it if I can't get a response from someone who might know. The ****ing factory doesn't even know....dumb ****s. They are about to go bankrupt and I can see why! I forget what toe-in and how much I used on my RV-6.... John |
Thread Tools | |
Display Modes | |
|
|