|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 24th 06, 01:51 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Aluminium Cowls
Hi,
Can anyone tell me what alloy is used for the manufacture of aluminium nose bowls on aircraft such as the Luscombe or C-140 or J-3 Cub ? Also how are they made (hand beaten, drop hammer etc ??) I assume they are formed in the 'O' condition ? If so are the heat treated subsequent to forming or is the strain hardening as a result of the forming process enough to harden and strengthen the metal ? Thanks, Steve 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about Alodine 1201 | Andrew Sarangan | Home Built | 20 | April 11th 06 01:31 PM |
| Blackbird v. Mig-25 | Vello Kala | Military Aviation | 79 | September 15th 04 04:05 AM |
| NEED: Source for 2 pcs Aluminium Plate 1 Inch x 4 inch 5 foot length | Spar | Home Built | 4 | March 11th 04 11:31 PM |
| NEED: Source for 2 pcs Aluminium Plate 1 Inch x 4 inch 5 foot length | Spar | Aviation Marketplace | 4 | March 11th 04 11:31 PM |
| NEED: Source for 2 pcs Aluminium Plate 1 Inch x 4 inch 5 foot length | Spar | General Aviation | 4 | March 11th 04 11:31 PM |
Threaded Mode