|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
January 20th 06, 02:32 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Master Buss Bar?
"ELIPPSE" wrote Hi, Jim! First off, remember its a fiberglass plane. I ran one bar down each side of the fuselage and put one layer of fiberglass over each. \\ Good idea. I'm not a glass kind of guy, so I might not have thought of that. -- Jim in NC 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Source for PA28-180 split master switch | Mike Noel | Owning | 3 | October 5th 05 02:29 AM |
| Master Jet Base | MICHAEL OLEARY | Naval Aviation | 24 | April 22nd 05 07:00 AM |
| Premade master and circuit breaker panel | Corky Scott | Home Built | 6 | March 19th 04 02:18 PM |
| ANG Woman Wing Commander Doesn't See Herself as Pioneer, By Master Sgt. Bob Haskell | Otis Willie | Military Aviation | 0 | March 18th 04 08:40 PM |
| Need G-103 Acro Master Cylinder | Ray Lovinggood | Soaring | 5 | September 30th 03 03:39 AM |
Hybrid Mode
