|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 25th 04, 09:01 AM
|
|||
|
|||
Reading the whiskey compass
When you're flying partial panel, to what precision do you read the
mag compass? To the nearest 5 degrees? Estimate to the nearest degree? How long do you go between readings and rely only on timed turns? For that matter, do you ever try to apply values from the correction card? In IMC or even VMC? -- Ben Jackson http://www.ben.com/ 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I took my check ride from this lady...worthwhile reading. | RobertR237 | Home Built | 9 | November 17th 04 02:06 PM |
| "Whiskey" for compass? | dale | Home Built | 10 | December 17th 03 11:16 PM |
| 3 1/8 inch compass | Steve Beaver | Home Built | 2 | October 21st 03 12:20 AM |
| I'm lost. Which compass? | Greg Burkhart | Home Built | 1 | August 12th 03 03:49 AM |
Threaded Mode