If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cleveland Wheel Shims
I need to add some shims to the axles of my Fly Baby to reduce the side-to-side
movement of my wheels (the axles aren't threaded at the end, the wheels are held on with a cross-bolt through a bushing). I basically need some thin metal washers with a 1.5" inside diameter. I'm suspecting the "Ring-Grease Seal" items on Cleveland 600x6 wheels is what I'm looking for. However, there are multiple part numbers for the same item (153-00300, 153-00400, etc.). I'm suspecting these are differing thickness...anybody got a table that shows the thickness by part number? Ron Wanttaja |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cleveland Nat Air Show | Woody | Aviation Photos | 0 | September 2nd 07 12:18 AM |
Cleveland Air Show.. what if... | Dave S | Piloting | 5 | September 3rd 04 01:59 AM |
IFR Through Cleveland | Bartscher | Instrument Flight Rules | 2 | June 2nd 04 04:22 PM |
Wheel pants for 6.00 x 6 wheel/tire | Wallace Berry | Home Built | 2 | January 23rd 04 04:22 AM |
Decent into Cleveland | john cop | Instrument Flight Rules | 19 | October 19th 03 06:09 PM |