If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#31
|
|||
|
|||
Electric Self Launch System
On Friday, October 26, 2018 at 5:34:13 AM UTC-7, Emir Sherbi wrote:
Craig, Thanks for the advice. That is the big issue on the project. Is difficult to obtain the same rigidity of a cone like the boom tail once cut. The reinforcement floor and walls will form 3 different enclosed sections with fibers at 45° from the fuselage line. After the modifications I will test the fuselage with strain gauges to see the new strain distribution and compare them with the original. Emir, Sounds like you've got it covered. It's always interesting to see whether the instrumented prototype matches the modeling. Best wishes, Craig |
#32
|
|||
|
|||
Electric Self Launch System
Craig,
Yes. But it is very difficult to model composites and worst to model sandwich structures. I am taking some consideration to model the worst case and build up from there. Later I'll test some specimens to see the performance of the layup technique and materials used. Emir |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Electric Self Launching System | Emir Sherbi | Soaring | 0 | June 4th 18 04:54 PM |
FES&electric system batteries | krasw | Soaring | 33 | February 25th 17 04:17 PM |
ASW24 - electric valve system | Norbert Gulczynski | Soaring | 1 | January 25th 15 01:13 PM |
Electric Duct Fan (EDF) Self-Launch Glider? | CLewis95 | Soaring | 26 | January 20th 11 06:27 PM |
Electric self-launch sailplane | CH | Soaring | 2 | September 14th 03 01:49 AM |